RoboCup Testing

Documentation and testing methods for evaluating different components and systems of the 2008 RoboCup Robots RoboCup Mechanical

Dribbler test

Functions:

Trap ball

• Ball speed- speed the ball can hit the without moving back. Use a spring and a speed trap to measure the speed.
• Ball angle- rotate the robot
• Rebound- distance the ball bounces back

Hold ball

• Center time- measure time in seconds
• Climb ball- measure change in normal force on the measuring platform
• Pull force- angle of loss of contact. Measure what incline the measuring platform is required for the dribbler to lose contact
• Reverse speed- have the robot on a treadmill and measure when the ball comes lose
• Lateral speed- have the robot on the treadmill but have the dribbler facing tangential to the motion
• Rotational speed- rotate the speed of the carpet and see when the dribbler loses control

Material Test

• Measure either the lifetime of the dribbler under continuous operation and visually inspect the dribbler.

Kicker Test

• Control speed- speed trap measuring velocity versus voltage
• Accuracy- impact test to measure where the ball impacts a wall
• Lifetime- how long does the kicker last both with a ball being hit and when there is no ball. Also measure changes in speed and accuracy over time.
• Frequency- how long between successive firings

Chipper Test

• Range- to where the ball lands
• Angle- accuracy to how close the ball lands
• Lifetime analysis same as kicker

Shell impact Test

• Maximum speed ball at different areas of the shell until it breaks

Omni wheels Test

• Traction- run the robot up an incline