RCmicro
Jump to navigation
Jump to search
The microprocessor is the heart of the 2007 robojackets robocup competition robot and acts as the interface between the wireless communication system and the robot proper. A simple firmware program monitoring the internal sensors of the robot and controling the motor and ball roller/shoot will run on the micro. Currently as part of our phase one objectives we are looking closly at processors from Atmel, SI Labs, Motorola, and PICs. Below are some specs.
The Wall
To Do
- Finalize number of I/O and type (SPI, PWM, ADC, etc)
- Design Schematic tying in all devices
- Breadboard to test write simple code
- Get board made
- Write Code
Specifications
| Device | 32-bit microprocessor |
|---|---|
| Power | 3.3V Low pwt |
| Archetecture | ARM |
| Clock | >50 MHz |
| Memory | Flash 128Kb |
| IO pins | 32-64 pins Software Configurable |
| Interfaces | SPI, UART |
| DA/AD | (3)10-bit DAC (2)10/16-bit ADC |
| Timers | 8-bit (3) |
| PWM | 4 channels |
| Programming | JTAG or Bootloader |
Schematics
Schematics
Articles
Article on Interfacing ARM processors and FPGAs
Possible Micros
Phillips LPC
- Sparkfun dev kit
- Phillips LPC213x series ARMs. Less memory than the LPC221x series but lower-power consumption and smaller footprint. Its still every bit as capable
- Phillips LPC221x series ARMs. More memory vs LPC2213x. COntains everything we need.
- Dev kit for LPC213x series $149.00. 2 issues: Do we have a JTAG programmer and if so will it fit the pin-out of this device?
AVR32
