RCmicro
Jump to navigation
Jump to search
The microprocessor is the heart of the 2007 robojackets robocup competition robot and acts as the interface between the wireless communication system and the robot proper. A simple firmware program monitoring the internal sensors of the robot and controling the motor and ball roller/shoot will run on the micro. Currently as part of our phase one objectives we are looking closly at processors from Atmel, SI Labs, Motorola, and PICs. Below are some specs.
The Wall
To Do
- Finalize number of I/O and type (SPI, PWM, ADC, etc)
- Design Schematic tying in all devices
- Breadboard to test write simple code
- Get board made
- Write Code
Specifications
| Device | 8 or 16-bit microprocessor |
|---|---|
| Power | 3.3V Low pwt |
| Archetecture | Atmel AVR |
| Clock | ? |
| Memory | Flash ?Kb |
| IO pins | 32-64 pins Software Configurable |
| Interfaces | SPI, UART |
| DA/AD | (3)10-bit DAC (2)10/16-bit ADC |
| Timers | 8-bit (3) |
| PWM | Yes up to 4 channels |
| Programming | JTAG |
Schematics
Schematics
