Glitchi

Glitchi
Year Of Creation	2026
Combined Wins/Losses	7/2

Glitchi is a vertical disk spinner and is kinda wide.

Competitions

Jacket Racket Spring 2026

• Results: 3-1
  • Bracket Style: modified swiss?
    • KO Win vs Mr. Peel
      • Shuffler undercutter
      • Went weapon on weapon and they bent my blade like 20 degrees
      • They then died because of the hit. no idea why but thank god
    • TO Win vs Singulariti
      • coughing bomb vs hydrogen baby
    • KO Win vs Finished Robot
      • Horizontal midcutter
      • Weapon died because the pulley fell off. The belt tension would slowly pull the motor more and more out of line, which eventually was enough to have the pulley fall off
      • Won through KO by controlling them and getting them stuck into the wall
    • KO Loss vs Astronomii
      • Vertical disk
      • Same thing as last match, but they drove better :(
      • Drive side also died because the plate holding my motor got bent up onto the top plate after a direct wheel hit

NHRL April 2026 XP

• Results: 4-1
  • Bracket Style: modified swiss?
    • KO Win vs Big Brain
      • Meltybrain that couldn't really melty
      • I never dremelled a flat in the motor shaft so a lot of why my pulleys kept falling off is because they'd just slip. pulley slipped here
      • Won through KO by getting them stuck
    • TO Win vs Regulus
      • Vertical beater
      • My favorite fight :)
      • Pulled out their weapon shaft, mangled their weapon motor mount, removed both side armor pieces, and bent a side of drive
      • They cracked my upright and sheared the bolt heads off of like half of my bottom plate screws
      • Functionally though it was chill
    • TO Win vs The Boom Stick
      • Shuffler midcutter, but its like really big
      • Hit their weapon out of their robot
    • KO Win vs Quinquereme
      • Thagomizer
      • Weapon never worked because the motor wouldn't stop cogging; still not sure why. Maybe I overtightened motor screws?
      • They just turned off after a while?
    • KO Loss vs Mark
      • Vertical disk (hubmotor)
      • pulley slipped of course
      • Got stuck upside down

Glitchi

Created by: Aaron Qu

Drive Motors	Repeat Tangent
Drive Motor Controllers	Repeat Dual Brushless
Weapon Motor	Badass 2315, 2300 kV
Weapon Motor Controllers	Specter 90A
Receiver	its the one we have hella of
Remote Control	its the one we have hella of
Battery	GNB 4s 1000 mAh

Problems

• TPU weapon hub is not the move
• Dremel a flat in the hub

Good aspects

• Weapon hits hard when it works
• Drives very straight
• Self righted sooo good, even without weapon
• No electrical failures (thank you deep 🙏)

Changes/Improvements

• Dremel a flat in the motor shaft
• SUPER PLA WEAPON HUB ‼️
• Toothed motor pulley instead of flat pulley to not rely as heavily on belt tension; this way theres less force bending the motor forward
• Wider aluminum washer/load spreader on the front of the motor to resist bending a lil more
• switch to radiomaster pocket for fun

Notes:

zero jds in 9 fights 😎