Dizzi
Revision as of 22:56, 20 May 2021 by Agunawan32 (talk | contribs)
| Dizzi | |
|---|---|
 | |
| Year of Creation | 2020-2021 |
| Versions | |
| Current Version | 1.0 |
| Update Year | 2020-2021 |
| Wins/Losses | 0/1 |
| Information and Statistics | |
| Weight Class | 2lb |
| Weapon Class | Ring Spinner |
| Combined Wins/Losses | 0/1 |
| Weapon Speed | 14,893 RPM |
2lb ring spinner made of a 3D-printed chassis with an aluminum, water-jet ring.
Contents
Competitions
2lb Competition 2021
- Results:
- Single Elimination:
- [L vs Guillotini]
- Weapon was disabled early into the fight due to weapon motor being dislodged
- https://www.youtube.com/watch?v=iG4C10TQex8
- [L vs Guillotini]
- Single Elimination:
Version
botName V1.0
Created by: Andrew Gunawan and Sydney Baker
| Drive Motors | 22mm DC gearmotor |
| Drive Motor Controllers | Scorpion Mini Electronic Speed Control |
| Weapon Motor | PROPDRIVE v2 2836 2300KV Brushless Outrunner Motor |
| Weapon Motor Controllers | HOBBYWING Platinum PRO V4 |
| Receiver | Hobby King 2.4Ghz Receiver 6Ch V2 |
| Remote Control | Hobby King 2.4Ghz 6Ch Tx and Rx V2 |
| Battery | Turnigy Nano-Tech 1000mAh 3s 45~90c LiPo Pack |
| OTHER: |
Problems
- Weapon motor unscrewed from the base likely from a hit during comp.
- TPU Ring slid up and down on the motor when the bot spun up
Good aspects
- Weapon spun up well, when nothing was interfering with it
- Quick weapon spinup
- The horizontal and vertical stabilizers held the weapon extremely well
- Under weight by 0.05 lb. (2.25 lb. of 2.3 lb.)
Changes/Improvements
- Hold the weapon motor down better
- More screws (only had 2)
- Maybe Loctite
- Find a way to keep the TPU ring stationary
- 3D printed rings above and below the TPU
- Reinforce the outer casing where the TPU could possibly hit
Notes:
The bot was named because it was intended to make people dizzy by looking at it.
Mentor: Darren Kosen Members: Andrew Gunawan and Sydney Baker
