Entropi

(Replace this text with an overall introduction of your robot's design, name, features, ect)

Competitions

Created by: (Names of Builders/Group Members of aforementioned version of bot)

Drive Motors	DYS BE1806 2300KV Motors
Drive Motor Gearboxes	KITBOTS 1000rpm Gearmotor Gearboxes
Drive Motor Controllers	DYS 20A Micro Opto Multi-rotor ESC
Weapon Motor	(Weapon Motor Name)
Weapon Motor Controllers	(Weapon Motor Controller Name)
Receiver	Turnigy T6A-V2 AFHDS 2.4GHz 6Ch Receiver V2
Remote Control	Turnigy T6A-V2 AFHDS 2.4GHz 6Ch Transmitter V2
Battery	Turnigy Nano-Tech 1000mAh 3s 45~90c LiPo Pack

(List of Problems, 1 per bullet point)
screws did not have enough contact, too shallow threads
tolerances between shaft and ball bearings resulted in shaking that caused screws to come out
large regions of useless aluminum on side plates
back plastic armor affected wheel contact
screws on hub (4-40) too thin to handle impacts
open access to electronics by spinning weapon
small bearings

(List of good aspects, 1 per bullet point)
side plastic armor for wheels prevented total destruction of wheel, lasted several hits from a kit beater bar
rear plastic armor allowed robot to not become trapped on a flat surface without wheel coverage.
heavy weapon and good weapon motor
drive while inverted
Sturdy axle
compact, easy access to electronics
low friction between axle and hub

(random joke, optional)

(Naming inspiration, optional)

(Names of original builders)