Difference between revisions of "Entropi"

Revision as of 18:31, 22 February 2019

(Replace this text with an overall introduction of your robot's design, name, features, ect)

Created by: (Names of Builders/Group Members of aforementioned version of bot)

Drive Motors	DYS BE1806 2300KV Motors
Drive Motor Gearboxes	KITBOTS 1000rpm Gearmotor Gearboxes
Drive Motor Controllers	DYS 20A Micro Opto Multi-rotor ESC
Weapon Motor	(Weapon Motor Name)
Weapon Motor Controllers	(Weapon Motor Controller Name)
Receiver	Turnigy T6A-V2 AFHDS 2.4GHz 6Ch Receiver V2
Remote Control	Turnigy T6A-V2 AFHDS 2.4GHz 6Ch Transmitter V2
Battery	Turnigy Nano-Tech 1000mAh 3s 45~90c LiPo Pack

(List of Problems, 1 per bullet point)
screws did not have enough contact, too shallow threads
tolerances between shaft and ball bearings resulted in shaking that caused screws to come out
large regions of useless aluminum on side plates
back plastic armor affected wheel contact
screws on hub (4-40) too thin to handle impacts
open access to electronics by spinning weapon
small bearings

(random joke, optional)

(Naming inspiration, optional)

(Names of original builders)

@@ Line 82: / Line 82: @@
 *(List of Problems, 1 per bullet point)
+*screws did not have enough contact, too shallow threads
+*tolerances between shaft and ball bearings resulted in shaking that caused screws to come out
+*large regions of useless aluminum on side plates
+*back plastic armor affected wheel contact
+*screws on hub (4-40) too thin to handle impacts
+*open access to electronics by spinning weapon
+*small bearings
 ==== Good aspects ====
 *(List of good aspects, 1 per bullet point)
+*effective armor allowed the absorbance of impacts
+*heavy weapon and good weapon motor
+*drive while inverted
+*Sturdy axle
+*compact, easy access to electronics
+*low friction between axle and hub
 ==== Changes/Improvements ====