Snuti

From RoboJackets Wiki
Jump to navigation Jump to search

Snuti is an invertible 3 pound drum spinner with armor made out of rounded 1/16 inch HDP. We chose a drum spinner design because we had heard that drum spinners have a relatively high success rate, and we chose to make our armor rounded because we wanted to see if it would take hits better than straight armor. Snuti's drum is roughly 1 pounds, and it spins up to 8,000 rpm.


Competitions

Motorama 2017

Version

Snuti V1.0

Drive Motors Pololu 9.7:1 Metal Gearmotor
Drive Motor Controller Scorpion Mini
Weapon Motor Turnigy D3536/6 1250kv Brushless Outrunner
Weapon Motor Controller Turnigy Plush 40A Controller
Receiver Hobby King 2.4Ghz Receiver 6Ch V2
Remote Control Hobby King 2.4Ghz 6Ch Tx and Rx V2
Battery Venom 35C 3S 1000mAh 11.1V LiPo Battery

Problems:

  • Armor pinched the wheel on one occasion, causing temporary loss of steering.
  • Drive motors were unreliable.
  • The belt driving the drum was not quite tight enough, so the drum could not slip.
  • Drum bearings did not turn as smoothly as possible and were slightly misaligned.
  • Belt became worn and loose, which influenced drum power.

Good Aspects

  • The rounded armor held up well against the opponents weapons.
  • The drum was effective when it worked.

Changes/Improvements

  • Reposition the drive motor mounts so that the wheel is centered behind the armor.
  • Try a flat belt instead of a V-belt.
  • Switch to better quality motors
  • Realign drum bearings