Difference between revisions of "RoboCup Electrical 2013"
Jump to navigation
Jump to search
(→On-Board Control) |
|||
| (10 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
==Current Activities== | ==Current Activities== | ||
* [[RC_Electrical_Kicker2013 | Kicker Design 2013]] | * [[RC_Electrical_Kicker2013 | Kicker Design 2013]] | ||
| + | * [[RC13HighStrengthEncoderWires | High Strength Encoder Wire (Prototype)]] | ||
==Systems== | ==Systems== | ||
| − | ===On-Board Control=== | + | === On-Board Control === |
<!--* [[RC12Brushless|Brushless Drivers]] | <!--* [[RC12Brushless|Brushless Drivers]] | ||
* [[RC12Wireless|Wireless Tranceivers]]--> | * [[RC12Wireless|Wireless Tranceivers]]--> | ||
* [[RC13Microcontroller | Microcontroller]] | * [[RC13Microcontroller | Microcontroller]] | ||
* [[RC13FPGA | FPGA]] | * [[RC13FPGA | FPGA]] | ||
| − | * [[ | + | * [[RCFirmware | Firmware]] |
| − | * [[ | + | |
| + | === Kicker === | ||
| + | * [[RoboCup:_Kicker_Board_2013 | Kicker Electronics]] | ||
| + | |||
| + | === Base Station === | ||
* [[RoboCup_Base_Station | Base Station]] | * [[RoboCup_Base_Station | Base Station]] | ||
| + | === Sensors === | ||
* [[RC13BallSense|IR Break-Beam Ball Sensor]] | * [[RC13BallSense|IR Break-Beam Ball Sensor]] | ||
* [[RC13IMU|Inertial Measuring Unit (IMU)]] | * [[RC13IMU|Inertial Measuring Unit (IMU)]] | ||
| + | === Power === | ||
* [[RC13Power | Power Supplies and Batteries]] | * [[RC13Power | Power Supplies and Batteries]] | ||
| Line 31: | Line 38: | ||
==Links== | ==Links== | ||
| − | [[Category: | + | [[Category: RC Electrical]] |
| + | [[Category: 2012-2013]] | ||
Latest revision as of 21:36, 24 May 2020
Contents
The Electrical System
The electrical system is all the electrical hardware and firmware used to operate the 2013 RoboCup team. It includes the host hardware, the wireless link, and the electronics for each robot.
Current Activities
Systems
On-Board Control
Kicker
Base Station
Sensors
Power
Some Ideas
- Ball sensor upgrade
- Upgrade IGBTs, since we seem to be running more current through them than they are rated for...
- Using analog hall effect sensors to eliminate optical encoders
- All on-board processing
- Move back to a kicker board design similar to the 2008 design (except with chipping, efficiency, and durability upgrades)
- Make stuff easier to be transported safely (e.g. to competitions)...
