Difference between revisions of "FIRST Kickoff Workshop"

From RoboJackets Wiki
Jump to navigation Jump to search
(The Plan)
(Programming Setup)
Line 60: Line 60:
 
* Speaker:
 
* Speaker:
 
* Room:
 
* Room:
 +
=====Objectives=====
  
 
===Documents===
 
===Documents===

Revision as of 19:57, 1 December 2009

Introduction

We will be building the basic kitbot using that materials given to you. There will be no cutting of metal

The Parts

We'll Bring - Materials

  • Pre-charged batteries
  • A 17' x 37'board to mount
  • Pre-Cut 10 AWG wire for the Jaguars
  • Pre-Cut 14 AWG wire harness for digital side car
  • A single 6 AWG wire for connecting the up the breaker
  • 6 AWG lugs
  • Velcro
  • E-net cable

We'll Bring - Tools

  • Crimper
  • "Tweakers"
  • Hammer
  • One set of socket wrenches
  • Cadre of hand tools

Teams Bring - Tools

  • Allen key set
  • Wrenches
    • 3/8", 7/16", and 10mm
  • Wire strippers, cutters, and crimpers
  • 1/4" and 3/8" bits and drill

Teams Bring - Out of the Kit

  • Anderson 120A breaker
  • Jaguars and PWM cables
  • cRio
    • Also get the two green 4-pos connectors
    • Locate connector for analog card
    • Be sure to place all the cards in the correct spot
  • Power Distribution Block
  • Digital side car
    • Also grabs its power connector
  • Wireless bridge
    • Grab power supply

The Plan

Mechanical

  • Speaker:
  • Room:

Electrical

  • Speaker:
  • Room:
  • Mount all the components using the velcro
  • Crimp the Anderson connector for battery
  • Connect power to Jaguars
  • Fab harness for digital side car
  • Fab harness for cRio then install
  • Fab harness for analog card and install
  • Cut and strip the power cable for the wireless bridge
  • Install it

Rules

  • Speaker:
  • Room:

Programming Setup

  • Speaker:
  • Room:
Objectives

Documents

Links