RoboCup Electrical 2013

The Electrical System

The electrical system is all the electrical hardware and firmware used to operate the 2012 RoboCup team. It includes the host hardware, the wireless link, and the electronics for the each robot.

Current Activities

• 2012 EE To Do List
• 2008 Kicker Rebuild
• 2011 Kicker Rebuild

Systems

• On Board Control
  • Brushless Drivers
  • Wireless Tranceivers
  • Power Supplies and Batteries
  • Sensors
    • Ball Sensor
    • IMU Sensor
  • Micro-Controller
  • FPGA
  • Firmware
• Kicker Electronics
  • Kicker 1.0 Errata
• Base Station

Future Ideas

• New motors
• Ball sensor upgrade
• Upgrade IGBTs, since we seem to be running more current through them than they are rated for...
  • No more stacking (unless we want to be on the safe side)
  • With the 2-stack mount
• Using hall effect sensors to eliminate encoders
• All onboard processing
• Move back to a kicker board design similar to the 2008 design (except with chipping, efficiency, and durability upgrades)
• Make stuff easier to be transported safely (e.g. to competitions)...