Snuti
Snuti is an invertible 3 pound drum spinner with armor made out of rounded 1/16 inch HDP. We chose a drum spinner design because we had heard that drum spinners have a relatively high success rate, and we chose to make our armor rounded because we wanted to see if it would take hits better than straight armor. Snuti's drum is roughly 1 pounds, and it spins up to 8,000 rpm.
Contents
Competitions
Motorama 2017
- Results:
- Bracket Style:
- 30 Pound Division
Version
Snuti V1.0
Drive Motors | Pololu 9.7:1 Metal Gearmotor |
Drive Motor Controller | Scorpion Mini |
Weapon Motor | Turnigy D3536/6 1250kv Brushless Outrunner |
Weapon Motor Controller | Turnigy Plush 40A Controller |
Receiver | Hobby King 2.4Ghz Receiver 6Ch V2 |
Remote Control | Hobby King 2.4Ghz 6Ch Tx and Rx V2 |
Battery | Venom 35C 3S 1000mAh 11.1V LiPo Battery |
Problems:
- Armor pinched the wheel on one occasion, causing temporary loss of steering.
- Drive motors were unreliable.
- The belt driving the drum was not quite tight enough, so the drum could not slip.
Good Aspects
- The rounded armor held up well against the opponents weapons.
- The drum was effective when it worked.
Changes/Improvements
- Reposition the drive motor mounts so that the wheel is centered behind the armor.
- Try a flat belt instead of a V-belt.