RoboCup Electrical 2013

The Electrical System

The electrical system is all the electrical hardware and firmware used to operate the 2013 RoboCup team. It includes the host hardware, the wireless link, and the electronics for each robot.

Current Activities

• Kicker Design 2013

Meeting Notes

• Sunday 9-9-2012
• Wednesday 9-12-2012

Systems

• On Board Control
  • Brushless Drivers
  • Wireless Tranceivers
  • Power Supplies and Batteries
  • Sensors
    • Ball Sensor
    • IMU Sensor
  • Micro-Controller
  • FPGA
  • Firmware
• Kicker Electronics
  • Kicker 1.0 Errata
• Base Station

Some Ideas

• Ball sensor upgrade
• Upgrade IGBTs, since we seem to be running more current through them than they are rated for...
  • IXGX400N30A3 (No stack)
  • IXGQ200N30PB (No stack)
  • IXGQ240N30PB (Dual-stack)
• Using hall effect sensors to eliminate encoders
• All onboard processing
• Move back to a kicker board design similar to the 2008 design (except with chipping, efficiency, and durability upgrades)
• Make stuff easier to be transported safely (e.g. to competitions)...