Difference between revisions of "Maori Design Guide"

From RoboJackets Wiki
Jump to navigation Jump to search
(Created page with "== Introduction == test == Design Basics == === Chassis === ==== Overview ==== test ==== Design Decisions ==== test ---- ;Notes/Helpful Advice : The water jet's tolerancin...")
 
Line 13: Line 13:
 
----
 
----
 
;Notes/Helpful Advice
 
;Notes/Helpful Advice
: The water jet's tolerancing isn't perfect, so when designing puzzle fits, add a tolerance of around 0.008 inches to both sides in order to ensure that the pieces fit together easily. This will save a good amount of time because you won't need to file the pieces to make them fit together.
+
: test
  
 
----
 
----
Line 26: Line 26:
 
----
 
----
 
;Notes/Helpful Advice
 
;Notes/Helpful Advice
: The water jet's tolerancing isn't perfect, so when designing puzzle fits, add a tolerance of around 0.008 inches to both sides in order to ensure that the pieces fit together easily. This will save a good amount of time because you won't need to file the pieces to make them fit together.
+
: test
  
 
----
 
----
Line 40: Line 40:
 
----
 
----
 
;Notes/Helpful Advice
 
;Notes/Helpful Advice
: The water jet's tolerancing isn't perfect, so when designing puzzle fits, add a tolerance of around 0.008 inches to both sides in order to ensure that the pieces fit together easily. This will save a good amount of time because you won't need to file the pieces to make them fit together.
+
: test
  
 
----
 
----
Line 54: Line 54:
 
----
 
----
 
;Notes/Helpful Advice
 
;Notes/Helpful Advice
: The water jet's tolerancing isn't perfect, so when designing puzzle fits, add a tolerance of around 0.008 inches to both sides in order to ensure that the pieces fit together easily. This will save a good amount of time because you won't need to file the pieces to make them fit together.
+
: test
  
 
----
 
----
Line 71: Line 71:
 
----
 
----
 
;Notes/Helpful Advice
 
;Notes/Helpful Advice
: The water jet's tolerancing isn't perfect, so when designing puzzle fits, add a tolerance of around 0.008 inches to both sides in order to ensure that the pieces fit together easily. This will save a good amount of time because you won't need to file the pieces to make them fit together.
+
: test
  
 
----
 
----

Revision as of 18:31, 3 October 2019

Introduction

test

Design Basics

Chassis

Overview

test

Design Decisions

test


Notes/Helpful Advice
test

Armor

Overview

test

Design Decisions

test


Notes/Helpful Advice
test

Drive

Overview

test

Design Decisions

test


Notes/Helpful Advice
test

Weapon

Overview

test

Design Decisions

test


Notes/Helpful Advice
test

Electronics

Overview

test

Drive

test

Weapon

test


Notes/Helpful Advice
test