RC09-Dribbler

Testing

Dribbler Bar Type

The current plan for the 2009 Dribbler is to have it be segmented. Segmenting creates two sections of dribbler with a gap in between. Theoretically, this allows for more ball control. The Mexican team used this set up in 2008 (see here). The gap in between is going to be between a quarter to a third of the length of the dribbler.

Performance Assessment

To measure last years performance and game play. This will be determined by receiving a kick and grabbing a stationary ball all under computer control. These results will be used as a benchmark to our new Dribbler model.

Pouring

We might want to look into pouring a mold of silicon rubber for the Dribbler assembly. This will be easier to put the rubber on the shaft. We don't know how well this will work, but we should do tests to see its effectiveness.

Candidates

1. 75115A65 McMaster-Carr ($17.89)

Obstacles

1. Make an outer mold.
2. Make inner mold/shaft.
3. Develop out gassing technique for pour.

Parts & Components

Motors

Dribbler Motor

Vendor - Maxon

Part No. - 266521 (with attached gear head 118184 5.4 gear reduction)

Cost - $146.20 each

Notes

Motor Data Sheet

Gearhead Data Sheet

Gearing

Motor Gear (Supplier A)

Vendor - WM Berg

Part No. - PFS80-46

Description - Module 0.5, 34 Teeth, 20° Pressure Angle, Stainless Steel Gear with hub set screw, 3mm bore, 23mm PD

Cost - $20.41

Drawing - Motor Gear Spec Sheet

Motor Gear (Supplier B)

Vendor - SDP/SI

Part No. - S10T05M046S0303

Description - Module 0.5, 34 Teeth, 20° Pressure Angle, Stainless Steel Gear with hub set screw, 3mm bore, 23mm PD

Cost - $13.96

Output Gear (Supplier A)

Vendor - WM Berg

Part No. - PFS80-26

Description - Module 0.5, 20 Teeth, 20° Pressure Angle, Stainless Steel Gear with set screw, 3mm bore, 13mm PD

Cost - $17.42

Drawing - Dribbler Gear Spec Sheet

Output Gear (Supplier B)

Vendor - SDP/SI

Part No. - S10T05M026S0303

Description - Module 0.5, 20 Teeth, 20° Pressure Angle, Stainless Steel Gear with set screw, 3mm bore, 13mm PD

Cost - $11.52

Stock

RTV

Vendor - McMaster-Carr

Part No. - 75115A65

Description - Loctite Gray Silicone Gasket Maker Number 18718, 2.36 Ounce Tube

Cost - $17.89

Shaft

Vendor - McMaster-Carr

Part No. - 8974K25

Description - Multipurpose Aluminum (Alloy 6061) 7/16" Diameter X 6' Length

Cost - $13.51

Action Log

1. 10/12/2008 - Segmented dribbler prototype design completed.
2. 10/16/2008 - Acquisition of silicone gasket sealer to test in mold.
3. 11/02/2008 - The spare dribbler from 08 was modified to be a segmented.

   Note - The rubber as damaged some while on the lathe. Patched was tested with gasket sealer.

4. 11/09/2008 - Impact tester was modified to allow for testing of receiving a pass.
5. 03/17/2009 - Housing preliminary sizing completed.
6. 03/18/2009 - Gearing Reselected.