RoboCup: Redesign 2014-2015

Phase I: Techanical Analysis

The first stage of the 2014-2015 RoboCup redesign involves brainstorming potential upgrades by researching new technologies/resources since the last revision. A parallel analysis of current robot bugs and potential enhancements is also done at this time. Outlined below is a listing of resources that the team used in it's brainstorming stage.

Competition 2014

Phase II: Design

Layout

Max PCB Dimensions

To Do

• Determine location and placement for dribbler motor header
• Update hall connection header to right angled one
• Determine optimal placemnt direction for drive motor phase connections (motor board)
• Add connection header for ball sensor to control board
• Update the 14-pin connection header (female) for the control-to-motor board connection
• Add pin locations to all connection housings in CAD part files
• Add wires among connections in CAD assembly files
• Finalize method for adjusting motor wire lengths when motors arrive
• Determine kicker connections and integration
• Determine placement of battery location

Radio

To Do

• Determine optimal secondary frequency for base station updates
• Order breakout boards for radio transceivers
• Test methods using breakout boards and compare data rates

FPGA

To Do

• Transition the I²C bus lines to the microcontroller
• Update Verilog for new balanced encoder signals (A+, A-, B+, B-)
  • ( (A+) + (A-) == 0 ) should be true for no errors

Motors

To Do

• Order motor controller boards
• Test different circuits and document data result set to wiki

Motion Sensing

To Do

• Create breakout board for MPU-9250 and place on GitHub repo (robocup-pcb)
  • ?Update EAGLE part libraries too

Error Detection

To Do

• Create breakout board for MCP23017 and place on GitHub repo (robocup-pcb)
  • Update EAGLE part libraries too

Battery & Power

The following contains a listing of batteries that were considered for the 2015 design along with other battery/power adapters and accessories.

Battery

Zippy Flightmax 2200mAh 5S 40C

Connector Lead

XT60 12AWG 10cm

Charging Lead

XT60 Banana Plug

Balancing Board

Charge/Balance Board

All Batteries

Zippy Flightmax 2500mAh 5S 20C

Zippy Flightmax 1800mAh 5S 40C

Zippy Compact 2450mAh 5S 35C

Turnig 2200mAh 5S 30C

Thunder Power 2000mAh 5S 16C

To Do

• Finalize method for connecting the battery to the motor board

Phase III: Production

https://learn.sparkfun.com/tutorials/electronics-assembly

http://www.soldermask.com/ <- Sparfun uses these guys for all their solder stencils