Difference between revisions of "RoboCup Electrical 2013"
Jump to navigation
Jump to search
(→Systems) |
(→Systems) |
||
| Line 16: | Line 16: | ||
** [[RC13Power | Power Supplies and Batteries]] | ** [[RC13Power | Power Supplies and Batteries]] | ||
** Sensors | ** Sensors | ||
| − | ***[[RC13BallSense|Ball Sensor]] | + | ***[[RC13BallSense|IR Break-Beam Ball Sensor]] |
| − | ***[[RC13IMU|IMU]] | + | ***[[RC13IMU|Inertial Measuring Unit (IMU)]] |
** [[RC12MicroController | Micro-Controller]] | ** [[RC12MicroController | Micro-Controller]] | ||
** [[RC13FPGA | FPGA]] | ** [[RC13FPGA | FPGA]] | ||
Revision as of 22:48, 17 September 2012
Contents
The Electrical System
The electrical system is all the electrical hardware and firmware used to operate the 2013 RoboCup team. It includes the host hardware, the wireless link, and the electronics for each robot.
Current Activities
Meeting Notes
Systems
- On Board Control
- Kicker Electronics
- Base Station
Some Ideas
- Ball sensor upgrade
- Upgrade IGBTs, since we seem to be running more current through them than they are rated for...
- Using hall effect sensors to eliminate encoders
- All onboard processing
- Move back to a kicker board design similar to the 2008 design (except with chipping, efficiency, and durability upgrades)
- Make stuff easier to be transported safely (e.g. to competitions)...
