Difference between revisions of "RoboCup Electrical 2013"
Jump to navigation
Jump to search
(→Some Ideas) |
(→Systems) |
||
| Line 5: | Line 5: | ||
==Systems== | ==Systems== | ||
| + | * On Board Control | ||
| + | ** [[RC12Brushless|Brushless Drivers]] | ||
| + | ** [[RC12Wireless|Wireless Tranceivers]] | ||
| + | ** [[RC12Power | Power Supplies and Batteries]] | ||
| + | ** Sensors | ||
| + | ***[[RC10BallSense|Ball Sensor]] | ||
| + | ***[[RC12IMU|IMU Sensor]] | ||
| + | ** [[RC12MicroController | Micro-Controller]] | ||
| + | ** [[RC12FPGA | FPGA]] | ||
| + | ** [[RC12Firmware | Firmware]] | ||
| + | * [[RC10KickerElectronics | Kicker Electronics]] | ||
| + | **[[RC10Kicker1Errata | Kicker 1.0 Errata]] | ||
| + | * [[RoboCup_Base_Station | Base Station]] | ||
==Some Ideas== | ==Some Ideas== | ||
Revision as of 15:23, 12 September 2012
The Electrical System
The electrical system is all the electrical hardware and firmware used to operate the 2013 RoboCup team. It includes the host hardware, the wireless link, and the electronics for each robot.
Current Activities
Systems
- On Board Control
- Kicker Electronics
- Base Station
Some Ideas
- New motors
- Ball sensor upgrade
- Upgrade IGBTs, since we seem to be running more current through them than they are rated for...
- Using hall effect sensors to eliminate encoders
- All onboard processing
- Move back to a kicker board design similar to the 2008 design (except with chipping, efficiency, and durability upgrades)
- Make stuff easier to be transported safely (e.g. to competitions)...
