Difference between revisions of "RoboCupMechanical2008"

From RoboJackets Wiki
Jump to navigation Jump to search
(Announcements)
(Announcements)
Line 8: Line 8:
  
 
==Announcements==
 
==Announcements==
 +
'''01-28-07'''
 +
Solid edge parts are updated along with the mechanical parts list.
 +
-John
 +
  
 
'''01-23-07'''
 
'''01-23-07'''

Revision as of 16:12, 28 January 2007

Mechanical System

This page breaks down the mechanical system of the Robots. The problem has been broken down into five phases as follows:

The Wall

Cornell Resource -Ryan

  • Have ya'll checked out these papers yet? They are definately worth looking at. --Andy 23:47, 26 September 2006 (EDT)

Announcements

01-28-07 Solid edge parts are updated along with the mechanical parts list. -John


01-23-07 I'm changing a few parts and updating the CAD - there is a lot to do...I'll be in the TIN today, and tomorrow...please stop by

01-18-07 Checking out plates holding axle - will also design support for motors. With the transfer from inventor no dimensions were put in SE - probably will also make it impossible to do the drawings. So I'm going to just remodel all parts in SE and send out a revised copy...Email me at gth722p@mail.gatech.edu with any questions.

-Jason

01-18-07 Drivetrain has been uploaded as Solid Edge .par files. The zip file can be found here: File:Solid edge.zip

-John


10-30-06 I will be late to the meeting.

To do list: 1)Create single document with all needed parts and part #'s for ordering.

2)Drive Train: Encoders we found, will not work. Electrical team is looking for another encoder. Work on CAD model, put in bearings for axles, and mounting plates. Cantilever wheels are ok.

3)Manipulator: Select components to populate order sheet (see above). Begin modeling in CAD.

-Ryan

Update 10-12-06

I edited the Dribbler page with some useful info.

-Pat

Found bevel gears, but we will still need a coupler or custom shaft. Bevel Gears (sdp-si) part #: A 1B 3MYK05040 - same gears, 1 to 1 ratio.

-Brian

Roadmap

  • Phase 1
    • Simple prototype with holonomic drive train made from the Vex Robotics kit (Complete)
  • Phase 2
    • Build a second fully functioning prototype
    • Kiwi drive system
    • Dribbler and shooter
    • Built to competition dimensions and requirements
  • Phase 3
    • Detail design of entire mechancial system
    • Five robots
    • Design Presentation to ME department
    • Technical Drawings (AutoCAD or Inventor)
  • Phase 4
    • Purchase parts and assemble robot fleet
  • Phase 5
    • Test system and update designs

Index