RCmicro

The microprocessor is the heart of the 2007 robojackets robocup competition robot and acts as the interface between the wireless communication system and the robot proper. A simple firmware program monitoring the internal sensors of the robot and controling the motor and ball roller/shoot will run on the micro. Currently as part of our phase one objectives we are looking closly at processors from Atmel, SI Labs, Motorola, and PICs. Below are some specs.

The Wall

9/14/06 - We chose a dev kit see the sparkfun link below. It'll cost $64.95 a pop and we are getting 3.

To Do

• Finalize number of I/O and type (SPI, PWM, ADC, etc)
• Design Schematic tying in all devices
• Breadboard to test write simple code
• Get board made
• Write Code

Specifications

Device	32-bit microprocessor
Power	3.3V Low pwt
Archetecture	ARM
Clock	>50 MHz
Memory	Flash 128Kb
IO pins	32-64 pins Software Configurable
Interfaces	SPI, UART
DA/AD	(3)10-bit DAC (2)10/16-bit ADC
Timers	8-bit (3)
PWM	4 channels
Programming	JTAG or Bootloader

Schematics

Schematics

Articles

• Article on Interfacing ARM processors and FPGAs
• Yahoo group about just the LPC ARM from Phillips

Possible Micros

Phillips LPC

• Sparkfun dev kit
• Phillips LPC213x series ARMs. Less memory than the LPC221x series but lower-power consumption and smaller footprint. Its still every bit as capable
• Phillips LPC221x series ARMs. More memory vs LPC2213x. COntains everything we need.
• Dev kit for LPC213x series $149.00. 2 issues: Do we have a JTAG programmer and if so will it fit the pin-out of this device?

AVR32

• ATMEL's answer to the ARM. Has everything including the kitchen sink.

Links

• Firmware

Electrical Homepage