RC08ProtoErrata

As we find board errata on the Prototype 1.0 (marked Feb 22 2008) they are listed below

Errata

~~3V3 Switcher diode is DPAK, should be SOT223~~ new switcher means new diodes...
~~FLASH should be SO8~~ ordered
Power switch footprint is incorrect
10uF caps are 0603 should be 0805
~~0.1 uF from SRST to GND on ARM~~ fixed
~~Pullup for the base of the buzzer transistor~~ fixed
~~TRST on ARM needs a pullup~~ fixed
~~WR needs to find a new pin on the ARM~~ fixed? may move for layout reasons
~~Mode2 Should go to jumper~~ fixed
~~Mode1 Should be tied low~~ fixed
~~DONE should be pulled to 2V5~~ fixed
~~PROGB should be pulled to 2V5~~ fixed

0603 pkg for diodes
~~Connect SRST to JTAG Connector~~
~~Notch filter for RX/TX~~ antenna switch?
~~New 3V3 supply~~
~~Smaller 1V2, 1V8, 2V5 supply~~
~~10A Fuse~~
~~Bigger motor caps (>150uF)~~ We can fit panasonic F on panasonic E pads (just taller formfactor). We will get 470uF.
Cap by power input (470uF)
~~Schottky diode on input to 3V3 rail, bigger input cap~~